ANTI TRACK KOTE – MRO 1016

Use ‘MRO 1016 – ANTI TRACK KOTE’ protective coating to insulate and seal: 

Armatures

Bus bars

Ceramic & plastic insulators

Commutator ends

End turns on electrical windings

Generators

Insulator bushes

Motor windings

Rewound motors

Stator coils

Terminals

Transformers

Highly suitable for insulating electrical windings that are exposed to extreme moisture and corrosive conditions as well as temperature and voltage fluctuations.

1. Possesses high dielectric strength, surface and volume resistivity to provide effective insulation of electrical equipment
2. Hard, durable & flexible protective film does not peel, crack or age and offers protective resistance to shocks, abrasion as well as aggressive chemical environments
3. Fast air-drying, stable, single component coating with excellent resistance against oils, chemicals, ageing, moisture condensation, weathering effects
4. Seals out moisture with a visible, highly glossy, smooth abrasion resistant protective coating
5. Highly heat resistant coating suitable for Class H insulation with greater allowance for thermal expansion and contraction
6. Prevents tracking, corona discharges, flashovers and electrical failures caused by water seepage
7. Very good adhesion on a variety of substrates
8. Oil resistant to ASTM D 115

500 ml Aerosol Can

Contains flammable solvents. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation

Shake can well before use. Clean thoroughly and dry the surface to be coated before application of this coating. Mask area not to be sprayed. Spray from 12-15 inches away in light, even coats with a sweeping action of the hand. Allow solvents to evaporate completely before re-application. Additional coats for heavy film can be applied when first coat is dry. Coating becomes dry to touch in about 20-30 minutes. Clean the valve by inverting the can and spraying a few short bursts till only the clear propellant comes out. Clean the actuator button orifice by means of a thin, fine wire.

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. Safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

Use in well ventilated areas. Avoid continuous breathing of vapour and spray mist. In closed areas or areas with poor ventilation, use respiratory protection. For complete details on safety, short and long term exposure, refer to this product’s safety data sheet (SDS).

24 months from date of manufacture

All used and unused product should be disposed of in accordance with state regulations.

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. User is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data offered without warranty.