HEATSHIELD – MRO 4025

Recommended for:

Commercial buildings

Warehouses

Factories

Metal tanks

Water tanks

Industrial & godown shades with GI

Cold storages

Computer server rooms

Electrical control panel rooms

Walking decks & balconies

Stair ways & pool area

Green buildings

1. Typical Reduction in Roof Temperatures
2. RCC terraces: 10°C to 15°C
3. Asbestos cement sheets: 15°C to 20°C
4. GI or powder coated sheets: Up to 25°C

20 Kg Container

NA

SURFACE PREPARATION: ON CEMENTITIOUS SURFACES

Surface to be applied upon must be free from dust, loose material, paint, oil, or any other material which may impair adhesion.

Mechanical means such as wire brushing & shot blasting can be used. Finally vacuum cleaning of all loose solids and liquids can be done if required.

All surface cracks should be filled up with proper sealants.

SURFACE PREPARATION: ON METAL SURFACES

Metal surface should be cleaned to remove existing paint, rust by appropriate mechanical or chemical means.

New surface should be de-greased and cleaned well

MIXING

Turn container upside down 6 hours prior to application.

Mix thoroughly using mechanical stirrer.

Over mixing more than 5 minutes may damage the particles and reduce insulation properties.

APPLICATION

Apply 3 coats of ‘MRO 4025 – HEATSHIELD’without any dilution by brush or roller at an interval of 2-3 hours.

Ensure that the coated area does not come in contact with water for at least one hour.

Apply with a quality brush, or roller.

For best results, Apply when surface and ambient temperatures are above 13°C and below 32°C.

After completion of full coating, it should be allowed to cure for 24 hrs. Drying time may vary due to temperature / humidity and surface condition.

AIRLESS SPRAYER:

Pump Ratio: 33:1 or larger

Volume: 1.5 gpm (5.7 lpm) or greater

Hose: 3/8” or larger with no more than 3’ of 1/4” whip. 1/2” hose recommended for Length above 50’.

Tip Size: 0.017” (for tight spots) 0.019─023” (normal use)

Pressure: Minimum of 3,000 PSI

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. Safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

NA

18 months if kept in a dry store.

All used and unused product should be disposed of in accordance with state regulations.

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. User is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data offered without warranty.