ELEKTRICIAN – MRO 1001

Helps to protect, lubricate and restore:

Alarm systems
Circuit breakers
Communication assemblies
Controls
Electrical connectors
Electronics
Generators
Instruments
Motors
Relays
Starters
Switch gears
Transformers

1. Convenient 360° (upside-down) spray valve for aerosols.
2. Cleans lubricates, protects, penetrates, and loosens corrosion.
3. Prevents corrosion by displacing moisture.
4. Restores resistance values by reducing current leakage.
5. Provides precision lubrication with its thin, high-dielectric strength, lubricating film.
6. Helps restore water-damaged electrical equipment.
7. Frees rusted or seized parts by penetrating into the finest pores and cracks.
8. Can be used on all metals and alloys.
9. Will not harm most modern plastics, painted surfaces, coatings, and rubbers. Test prior to use.
10. Non-flammable CO2 propellant, giving more active product content.

500 ml Aerosol Can

Spray light even coat to protect surfaces and to seal out moisture.

Apply liberally to loosen rusted parts.

Spray wet surfaces until run-off is clear and moisture free.

Before surface treatment with ‘MRO 1001 Elektrician ‘ clean the surface with ‘MRO 1004 – Electric Motor Kleaner’.

Do not use on energized equipment; allow the solvent to evaporate before energizing. This evaporation may take up to 4 hours, depending on surface condition and the environment. Use only in a well-ventilated area.

Contains flammable solvents. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. Safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

Use in well ventilated areas. Avoid continuous breathing of vapor and spray mist. In closed areas or areas with poor ventilation, use respiratory protection. For complete details on safety and short and long-term exposure, refer to this product’s safety data sheet (SDS).

All used and unused product should be disposed of in accordance with state regulations.

24 months from date of manufacture

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. The user is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data is offered without warranty.