PIPE WRAP (100mm X 3.6m) – MRO 8023

Impact protection

Emergency repair

Corroded pipes

Irregular pipe fittings

Force mains and gravity lines

Joint and tee repair

Underwater repair and splash zone

1. Bonds to most of the substrates
2. Ready to use & versatile
3. Effective & time-saving
4. No mixing and no mess
5. Sets rock hard in minutes
6. Permanent repair
7. Corrosion resistant

1 No (100mm x 3.6 m) Hermetically sealed foil pouch

For complete safety and handling information, please refer to Material Safety Data Sheets (MSDS) prior to using this product.

SURFACE PREPARATION

Once the leaking area is identified, shut down relevant pipes or hoses immediately wherever possible.

Prepare the surface by cleaning and roughening the pipe to ensure maximum Prepare area at least 3 times of the damaged area.

Put on Nitrile gloves.

Apply MRO 8051-S Stick, knead till uniform consistency, press to fill holes/cracks/voids and hold till leakage The mechanical bond that is created in this step is critical to the performance of the repair system.

APPLICATION PROCEDURE

Open the foil pouch and immerse MRO 8024 – Pipe Wrap bandage in temperate fresh water for 10 Seconds to activate. The entire contents must be used once the package is opened within approximately 2 minutes.

Apply MRO 8024 – Pipe Wrap around the damaged area extending up to 50mm on either side of the leak to ensure complete coverage. It is important that the bandage is applied quickly as curing begins once it is taken out of the water.

Whilst wrapping, pull each layer tightly by using your hand to mould and squeeze the layers together. Continue this action during and upon completion.

The indirect heat may be applied to accelerate cure times if required.

The wrapping should be done a minimum of 4 times around pipes or 4 times of wall thickness whichever is higher.

Keep working the urethane back into the tape while moulding and pressing the tape until it has lost its initial tackiness.

The higher temperature & chemicals, if within specified limits, do not cause any softening of the bandage.

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. The safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

Use in well ventilated areas. Avoid continuous breathing of vapour and spray mist. In closed areas or areas with poor ventilation, use respiratory protection. For complete details on safety, and short and long-term exposure, refer to this product’s safety data sheet (SDS).

A shelf life of 2 years from date of manufacture can be expected when stored at room temperature (22ºC) in their original foil pouch.

All used and unused product should be disposed of in accordance with state regulations.

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. The user is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data is offered without warranty.