CHEMPRO – MRO 3000

Acid fume proof roofing

Boiling water tanks

Buried tanks and vessels

Desalination plants

Offshore risers, piles

Pipe lines, fittings, valves

Solvent extraction systems

Water treatment plants

Waste water pipes and other steel structures in need of a high performance protection

1. High temperature and chemical resistant high build coating
2. No VOC . 100 % solids superior Novolac polymer system
3. Excellent cathodic disbondment characteristics
4. Excellent wastewater and sulphuric acid resistance
5. Suitable for pipeline operating temperatures to 120°C
6. Resistant to thermal shocks and freeze-thaw cycles
7. Abrasion and corrosion resistant
8. Resistant to sea water
9. Can be applied directly on prepared substrate without using a primer
10. Smooth, glossy, easy to clean surface
11. Easy to apply solvent free formulation makes it suitable for use in confined spaces

5 Kg (Part A  4 Kg & Part B 1 Kg Containers)

For complete safety and handling information, please refer to Material Safety Data Sheets (MSDS) prior to using this product.

SURFACE PREPARATION

All surfaces to be coated should be clean, dry and free from contamination. Prior to paint application all surfaces should be assessed and treated in accordance with ISO 8504:2000. Where necessary, remove weld spatter and where required smooth weld seams and sharp edges. Oil or grease should be removed with ‘MRO 1011 – KLEANER DEGREEZER’

Abrasive Blast Cleaning:

This product must only be applied to surfaces prepared by abrasive blast cleaning to Sa 2 ½ (ISO 8501-1:2007) or SSPC-SP10. A sharp, angular surface profile of 50-75 microns (2-3 mils) is recommended. ‘MRO 3000 – CHEMPRO’ must be applied before oxidation of the steel occurs. If oxidation does occur the entire oxidized area should be re-blasted to the standard specified above. Surface defects revealed by the blast cleaning process should be ground, filled or treated in the appropriate manner.

Power Tool Cleaning (Small Areas Only)

Steel surfaces:

Ensure surface is clean, dry and free from metal corrosion prior to coating ‘MRO 3000 – CHEMPRO’. Light sweep with non metallic, and chloride free abrasive (e.g. aluminium oxide or garnet) to obtain anchor profile of approximately 50 microns.

MIXING

Mixing of product should be carried out using slow speed mixers and completed by adding to the part “A”, the part “B”. Ensure the mix is homogeneous and free from lumps. Avoid air entrainment. ‘MRO 3000 – CHEMPRO’ can be applied either by airless spray, brush or roller.

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. Safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

Use in well ventilated areas. Avoid continuous breathing of vapour and spray mist. In closed areas or areas with poor ventilation, use respiratory protection. For complete details on safety, short and long term exposure, refer to this product’s safety data sheet (SDS).

24  months if kept in a dry, air conditioned store between 5°C and 30°C in the original, unopened containers.

All used and unused product should be disposed of in accordance with state regulations.

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. User is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data offered without warranty.