DRIVE BELT DREZING – MRO 1007

For use on all round, flat & V-belts in:

Air conditioners
Compressors
Conveyors
Fans
Farm machinery
Industrial belt drives including generators
Motorized equipment
Powertools
Pumps
Textile machines
Transmissions
Vehicles

1. Increase pulling power of belt
2. Protects belt from deterioration due to oxidation and heat
3. Remains soft, does not harden or glaze
4. Easy application, aerosol spray for maximum coverage, extension tube for hard to reach areas
5. VOC compliant
6. Can be used in wet outdoor conditions

500 ml Aerosol Can

Contains flammable solvents. Do not spray near naked flame, hot surfaces or energized equipment. Use with adequate ventilation

Provide adequate ventilation.

Shake can thoroughly before use. Note: There is no ball agitator inside the can. For best results, aerosol can should be at room temperature before spraying.

Attach extension tube

While engine is running, spray lightly on inner working surface of belt near smallest or uppermost pulley. Allow belt to run for several minutes to condition and cure dressing . Reapply as needed. Caution: Do not come into contact with moving parts.

Do not apply an excess, a uniform, thin coat is sufficient. If the liquid runs off, it indicates an over-application

Read instructions on the container label of the product before use. The product safety data sheet (SDS) contains the relevant information regarding PPE, safe use, and physical & health hazards. Safety data sheet is available from MRO INFRA or your local MRO INFRA Channel Partner.

Use in well ventilated areas. Avoid continuous breathing of vapour and spray mist. In closed areas or areas with poor ventilation, use respiratory protection. For complete details on safety, short and long term exposure, refer to this product’s safety data sheet (SDS).

24 months from date of manufacture

All used and unused product should be disposed of in accordance with state regulations.

The information and data contained in this sheet is accurate to the best of our knowledge or is obtained from sources, tests or experiences believed by us to be reliable and accurate. User is responsible for determining whether recommended MRO INFRA product is fit for a particular purpose. All products should be tested for suitability on a particular application prior to actual use. We make no representations of any kind. Data offered without warranty.